Since I put the tach in I ran a couple of tests on my coolant leak problem. I followed the Bentley instructions, parked the van on an incline, front of van about 4" higher than back. Opened the front bleeder valve and the rear bleeder valve, ran the van at 2000 rpm until coolant started flowing freely from front. Closed front valve, waited about 10 minutes and still nothing from rear bleeder valve, (both coolant hoses below the van were hot, and so was the hose that the rear bleeder valve is on) so I removed my penny from the throttle and let it go back to idle, as soon as it went down from 2000rpm I watched the coolant level in the expansion tank start to skyrocket! Still nothing from the rear bleeder valve. It started overflowing from the top of the expansion tank, there's a little nubbin at the very top of the expansion tank which I suspect is a vent, and that's where the coolant leak is coming from. This all happened within about a minute of dropping the rpm's from 2k to idle... The coolant was bubbling as I watched it rush back into the coolant tank. Any suggestions or ideas? Thanks, David / NJ 85 Wolfsberg Westy "Beatrix" http://home.comcast.net/~maurio11/index.htm |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.