Date: Sun, 21 Sep 2003 11:04:31 -0600
Reply-To: Bob Stevens <mtbiker62@HOTMAIL.COM>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Bob Stevens <mtbiker62@HOTMAIL.COM>
Subject: Re: Sunday morning, radiator change
Content-Type: text/plain; charset="iso-8859-1"
... some answers to some of your questions.
BLEEDING THE COOLING SYSTEM
I've heard more ways to bleed the cooling system than you can imagine.
Some may even work. Here's what I do. Its simple and it works. This is
done only then the engine is cold. Coolant, when heated up to running
temps, will give you a good burn. I lift the nose of the van about 4 inchs.
Fill the cooling system with coolant. Let stand ten or fifteen minutes with
heater valves open. Top off again, and let stand for another five minutes.
For the best results, remember to pre-mix fresh coolant with equal amounts
water. Next, start the van with at least a full jug of pre mixed coolant at
your side. Rev the engine to 1,500 rpm and expect to pour coolant in the
expansion tank. Don't let it get low. When the coolant is coming out of the
radiator in a steady stream, plug the bleeder in and tighten it. Top of the
coolant, tighten the cap, let off the gas, and you're done. This has worked
for me repeatedly.
....and:
http://www3.sympatico.ca/huotx/bleeding.htm
Bob Stevens
http://groups.msn.com/BobsPhotoShare
http://groups.yahoo.com/group/tiico
----- Original Message -----
From: "VWNut Hawk" <vwnut@HAWKCOMPUTING.COM>
To: <vanagon@GERRY.VANAGON.COM>
Sent: Sunday, September 21, 2003 10:27 AM
Subject: Sunday morning, radiator change
> Good morning all,
>
> I am replacing the radiator in my son's 84 Vanagon this morning. I
> have the old one out.
> I'm looking for any advice and information about this process. I will
> search the archives in a minute but
> thought I'd see if anybody wanted to help by typing some info in now.
>
> The new radiator from Bus Depot is from South Africa and is much
> lighter. It appears to
> be an exact replacement and has VW marking on it.
>
> I took the rubber cups off the corners of the old one and transfered
> them to the new one.
> I plan on sanding and painting the fan shroud.
>
> There is a brass screw at the top of the radiator. Is this a bleeder
> screw and how do I fill the system back
> up? I've seen and read many postings of jacking the back of the
> Vanagon up and running without the
> pressure cap on while filling the tank at the back. The rpm's are
> suppose to be kept up above idle right?
>
> Is there a quick check for the thermostat? I forgot to order a new
> one. Am I suppose to use a sealant around
> the threads?
>
> Should I rig up a flush and flush out the entire system now?
>
> Thanks.
> John.
>
|