My mind says Idle Stabilizer Control Unit. Search the archives for ISCU... there is ample info on this rather complex and pricey system. The Idle Stabilizer Valve (ISV) is also involved, and often one of the parts fails and kills the other. Be careful if replacing, as you may find that the new replacement gets a burnt out transistor if the other part was bad. good luck! RSF IMPORTANT!!! In order to reply to me, you must have the word "FISH" somewhere in the subject line of the email. Otherwise it goes directly in the trash. <º)))>{ <º)))>{ <º)))>{ <º)))>{ <º)))>{ <º)))>{ Robert S. Fish Salzburg, Austria 1987 Wolfsburg Vanagon 2.1 GL Weekender 1987 Golf Cabriolet 1991 Golf > J. > The first thing that comes to mind is the TEMPII sensor. > > Ken Lewis > ----- Original Message ----- > From: "J. Naser Motlagh" <JNMOTLAG@SPRINTPCS.COM> > To: <vanagon@GERRY.VANAGON.COM> > Sent: Friday, September 26, 2003 8:14 AM > Subject: High idle after warm up > > > > I have recently replaced my engine, and it runs great. However, after it > > is warmed up my idle shoots up to 2000 rpms, then it cycles between 1900 > > and 2100 in about 3 second intervals. Any quick thoughts? > > -- > > J. Naser Motlagh, MBA, PMP > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.