Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (September 2003, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 22 Sep 2003 17:43:50 -0700
Reply-To:     Doktor Tim <doktortim@ROCKISLAND.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Doktor Tim <doktortim@ROCKISLAND.COM>
Subject:      CV Bolt Heads
Comments: cc: type2@type2.com
In-Reply-To:  <3F6F1CDB.4010807@verizon.net>
Content-Type: text/plain; charset="us-ascii"; format=flowed

Just in case you are not already aware, you must take the time with picks/scribes/little looooooong screwdriver and clean the heads of the CV bolts. Dirty job. first knock of the big chunks with a wire brush, then dig out the heads inside and outside, then spray with PB Blaster, then clean the insides again. If you just jam the tool into those dirty heads, you will wear out the tool before you finish and strip a bolt. It takes more time to clean the bolts than it does to remove them.

So why not as standard procedure, when you put back new or cleaned bolts, pack some 1950's type high fibre wheel bearing grease in the heads. Bosch dizzy cam grease is similar. They would still build up crud all around, but once you knocked off the chunks, they would be easy to clean the inside of grease and no debris. Simple idea and wouldn't surprise me if it is in the archives somewhere.


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.