Date:         Sat, 4 Oct 2003 18:53:42 EDT
Reply-To:     DVWImports@AOL.COM
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Don Deitke <DVWImports@AOL.COM>
Subject:      Re: 228mm Flywheel Resurface Question
Comments: To: jstric01@CS.FIU.EDU
Content-Type: text/plain; charset="US-ASCII"

Taking of a few thousands will give you a flat level surface for your new
clutch to ride true. it will also take off the glaze which was created from the
old clutch .This will give you better clutch bite. It should be done with every
new installation !! You should have plenty of meat to do it several times .
You should have a good auto machine shop in your area .
                                              Don at DVW Imports

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.