At 10:09 PM 10/8/2003, Todd wrote: >I'm trying to assemble the linkage to a 5spd 094 transmission but can't >figure out where two parts go. > >If you look at the diagram in Bentley, on page 34.10 under the >gearshift lever there is a spring and ball shown directly underneath - >but I can't for the life of me figure out where they go. If you placed >them as shown in the diagram, the parts would simply fall out. > >Has anyone done this and know where they go? --- Uh huh, I did it a couple weeks ago... Didn't have any trouble though, the little paragraph to the left side of the page describes how to assemble. The upper and lower ball halves and one spring go inside the 2 shell halves. The shell halves go inside the rubber guide, which holds it all together. Don't forget to lube the parts! Steve EJ22 -> '86 Westy "Escape Pod" |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.