My solution was to find an old factory exhaust with the CO port. Cut the port off the factory pipe, and have it welded to the S&S pipe. Was not a big deal and works fine. It was one of the easier problems to fix with the S&S headers. Todd '88 Westy
-----Original Message----- From: lauterba <lauterba@BELLSOUTH.NET> Sent: Oct 10, 2003 3:37 PM To: vanagon@GERRY.VANAGON.COM Subject: Setting CO with S&S header I need to have my local shop set my CO level as I have new AFM on new engine. I have S&S headers so there is no exhaust sampling port upstream from the catalytic converter. Where should the CO probe be placed to measure the CO? Engine is 1.9K WBX. John Lauterbach Macon, GA '84 7-passenger |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.