Greetings, all. I'm reassembling the right side of my 1990 Vanagon's engine after a poorly installed (by a pro shop, no less) rubber waterjacket/head gasket leaked and had to be replaced. Everything's apart, cleaned and ready to go back together. Is it usual practice to apply a tiny bit of sealing goop (I'm using the non-hardening stuff) to the block surface where the inner end of the cylinder sleeve contacts it? I'm pretty sure that the outer end where it contacts the cylinder head must be a dry fit, but the inner side has me in a bit of a puzzlement. Nothing is mentioned in The Book about sealing goop there, but then again the book doesn't really give particular mention to sealing goop technique anywhere else, either. I see evidence of what might have been a thin smear of goop on the mating surface at the block, but it might just be the remains of a bit of oil blowby that's turned to tar. Any thoughts and experiences would be helpful. By the way, unlike my other previous (air cooled) VW Beetle and Van engines I am finding the task of working on this engine to be less than a pleasant experience. I have found a ton of things where I scratch my head and ask "Now why did they do that?", quite unlike the typical German "logical reason for everything" approach that I saw in the earlier models (and in general in my BMW motorcycles). I know that it may upset some of the faithful, but this whole water jacket thing is a stinky design IMO.
Regards, Rob It's never too late to have a happy childhood. -=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=- Rob Scott, mailto:rob@unixguy.com Langley, Washington on Whidbey Island (a suburb with a moat) |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.