Hello all, My Westy w/ 2.1L w/ Digifant is running fine when cold, and also when it goes through a full warm-up cycle (5 miles+). However, if I only drive a couple or three miles, then shut it down for a while (grocery store run), it starts hard, blows white smoke, and will only accelerate from idle if I floor it with no load. Once it's going again, it seems kinda OK, but a little doggy. The idle valve is disconnected, I've found no vacuum leaks, and the temp II sender seems OK, though I haven't used a voltmeter on it. Suggestions? Thanks, Karl Wolz |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.