Date:         Wed, 12 Nov 2003 19:34:16 -0500
Reply-To:     Jonce Fancher <strtbug@ATTGLOBAL.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Jonce Fancher <strtbug@ATTGLOBAL.NET>
Subject:      Re: speedometer no move
Comments: To: VWNut Hawk <vwnut@HAWKCOMPUTING.COM>
In-Reply-To:  <sfb20010.041@ns1.hawkcomputing.com>
Content-Type: text/plain; charset="iso-8859-1"

the problem is more then likely the lower cable from the spindle to the
black box. to check it reach under the bus and grab the cable housing (
black ). and try pushing it as hard as you can toward the spindle. what
happens is the cable wears out the black outer sleeve over time and
when you turn it pulls the inners out. from there you could also
disconnect the cable from the box and spin the wheel and look at the
cable this will tell you if it is just broken. hope this helps. my 85
did the same thing also west coast metric is starting to carry cables
and such for most vws so you can always contact them or flaps. c-ya
Jonce

>Good morning fellow VW repair people.  I've gotten pretty good at
>estimating the speed of the blue 84 by
>the sound and the other traffic.  I am on a mission to fix everything
>on at least one of my buses.
>So I have the speedometer out.  I used a drill to spin it and the
>needle moves fine.
>Therefore my problem must be one of the cables, or the little gear box
>under the bus?
>Unless I hear some advice from you all, I think I'll jack up the front
>drivers side whell and spin it
>as I inspect the cables underneath.  Is this the next step?
>Thanks.