i know one of our resident germans has performed a mid-engine swap on his van using the audi longitudinally mounted v6+transaxle (which normally powers the f wheels) and shifting it back to the r wheels as a unit. i am thinking of going the non-german way yet again, and using either ford or chevy components in a mid engine swap. to keep cost down, i would need to use a ford/chevy transmission. my uncertainty is that the output shaft on the transmission will not directly bolt up to the input shaft on a rear diff. or, if i use a "driveshaft" of sorts, it would bind constantly from being at a not-normal angle. the other option in my mind would be to slide the rear end further back, thereby extending the wheelbase of the van, but that brings up another set of problems.. namely sheetmetal fabrication. anyways, if poeple have comments/suggestions, please reply-all, for flames just pmail me to keep them off the list ;) TIA. ~sudhir |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.