Through the roof on each side, GE silicone II sealed, straight down to right where the front of the rear internal roof/upper bed support ends. One side goes goes across underneath the front trim of same, where it meets the driver's side drop. From there both go towards the back in the odds and ends channel to the ammeter which is above the "closet" door. After the ammmeter, down the side of the closet facing, and into the area under the bench seat. On the front of the bench seat is the charge controller, which then feeds back under the bench seat to the deep cycle, which is on the extreme drivers side. The deep cycle fits perfectly in the nook next to the heater box. I also have a 35 amp 12 volt Astron switching power supply and a 300 watt inverter on top of the heater box. This, along with a few high current molex connectors, lets me cover a lot of useful combinations. tom On 17 Nov 2003 at 20:05, Felder wrote: > Where are you wiring them in? > > > Thanks, > > Jim ------ Tom Ring K0TAR, ex-WA2PHW EN34hx 85 Westphalia GL Albert 96 Jetta GL The Intimidator taring@taring.org "It is better to go into a turn slow, and come out fast, than to go into a turn fast and come out dead." Stirling Moss |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.