Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (November 2003, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 16 Nov 2003 17:25:54 -0500
Reply-To:     Dennis Haynes <dhaynes@OPTONLINE.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Dennis Haynes <dhaynes@OPTONLINE.NET>
Subject:      Re: unidentified cable and oil spout connector
Comments: To: Jason Pufahl <jasonpufahl@HOTMAIL.COM>
In-Reply-To:  <Law10-F1268sNcxqkwT0000efce@hotmail.com>
Content-type: text/plain; charset=us-ascii

The oil filler was a molded in place assembly. The plastic portion was not to be separated or replaced. It is probably cracked from being separated. This assembly should be near air tight. A new one is on order.

The cable and that mess it is connected to looks like some type of aftermarket cruise control. Finish the removal.

Dennis

-----Original Message----- From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of Jason Pufahl Sent: Sunday, November 16, 2003 4:19 PM To: vanagon@GERRY.VANAGON.COM Subject: unidentified cable and oil spout connector

Hello all...

I am fixing my Vanagon finally. Took the engine out and replaced tons of stuff. I'm not a mechanic, but have had help....

Anyway, since I have owned the van there has been a cable, near the throttle, that has never been attached. I am hoping someone can tell me what it does. I have taken pictures of the cable, as well as the electrical thing that it attaches to underneath the van. I can't find it in my bentley since I don't know what to look for.

Also, I am trying to reconnect my oil spout. I know where it came off, but I can't figure out how to get it back on. The spout just seems too small to fit over the metal part. Is there a trick to this, am I missing something simple?

After this it is on to the shocks, and then some little odds and ends. Hoping to be done in the next week or so.

Here is the link to the pictures, which should show what I am trying to figure out....

http://onehop.homedns.org:8080/_sgt/m5_1.htm

Thank much...

Jason

_________________________________________________________________ Frustrated with dial-up? Get high-speed for as low as $26.95. https://broadband.msn.com (Prices may vary by service area.)


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.