Hmmm, this is a good point. But I am thinking of things I have read that talk about the one wire in the aux batt relay circuit being a smaller wire specifically to limit the amount of current going between the 2 batts. So, if my starting batt is discharged, and I close the relay manually with my system, how is that different from my aux batt being discharged and I start the engine? Now, suppose my starting batt is discharged and I have the relay closed with my system, and I try to start the engine. Big load hits the dead starting batt, and tries to draw off the aux batt through the small wire. Does the size of the wire limit the amount it can draw off the aux batt, or does the wire overload and get hot and burn my van up with me in it? Is the amount of load the difference between the 2 scenarios? If I run my aux batt totally flat then start the engine, wouldn't that put a pretty big load on the wire connection and relay between the 2 batts? Edward At 09:59 PM 12/4/2003, you wrote: >Edward, DON'T do it that way. The stock aux bat wiring is not large >enough to safely allow the aux battery to be connected during starting. >The starter motor can draw way too many amps for that small wire. That >is why VW connected the relay in such a way that it is not connected >unless the alternator is charging. They even hooked the controls for the >relay to the starter circuit such that it disables the relay when you >are trying to start. They did this as a double safety precaution. > >In other words VW designed the stock aux bat system to prevent exactly >what you wish to do. Don't simply bypass their protection measures. > >You need to upgrade the relay and the wires that connect to it from each >battery. To do less is very risky. You may get away with it for a time >but it disaster may ensue. > >Mark > > >Edward Maglott wrote: > > > > I was looking at a way to hook the aux and vehicle batteries of the Westy > > together. I have a charger set up on the aux batt, so that it gets charged > > whenever the vehicle is plugged in. I would like to connect the two so > > that the vehicle batt can share in that charging when needed. Or let the > > aux batt boost the vehicle batt when needed. So I thought, there's already > > a relay in place to do this. How about a little switch to energize the > > coil on that relay? I tried applying 12V to the blue wire and that did the > > trick. So then I started to find a switch to install for the purpose. Now > > I am thinking about where that 12V is going to go when it also travels back > > down the blue wire to the alternator. Is this a bad idea? Thanks for any > > input. > > > > Edward |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.