In a message dated 12/1/03 6:38:31 AM, phlogiston@ISPWEST.COM writes: << who makes good drills these days? --- Cleveland Twist. (Wait, if you mean drill motor, Milwaukee) do i need an extra-long one to reach into that space inside the trailing arm? --- Or a drill extension. is it possible to do this drilling without damaging the cv's boot? --- It depends on how careful you are. If you have any doubts, use a couple of layers of duct tape to protect the boot. my new cv joints didn't come with retaining rings, how bad is it to reuse the old ones? --- Not ideal, but, done with care, possible. any advice on where to get a 12point driver socket? --- NAPA >> George |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.