Hi all and Merry X-mass to all Since the last post I have cleaned all earths Replaced Leads and Cap. Moved wiper plate in AFM. Added the Capcitor fix to AFM. Replaced temp 2 sensor. adjusted throtle switch to correct settings. Checked all readings from ECU to relative parts all fine. checked idle stailizer valve and unit ( electricals). Adjusted CO content by voltage of the O2 Sensor. Cleaned Idle stabilizer valve. Tune up to correct position. Compression test all cylinders are at 145psi. Question is still have miss through out rev zone and idle any ideas? Symptoms are start van runs smooth for 30 seconds then miss kicks in. There is no valve noise at all. After compression test all cylinders are equal 145psi. I am at a loss what futher to check and need some help from any one please? If there is any one from the Sydney area of NSW Australia that is willing to help diagnos this problem by swaping parts plaese let me know. Thanks SyncroPete. 92 VW Syncro Transporter Push bike LOL. |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.