Date:         Sun, 21 Dec 2003 02:26:09 -0500
Reply-To:     Peter Pollard <neptunesguitars@SWIFTDSL.COM.AU>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Peter Pollard <neptunesguitars@SWIFTDSL.COM.AU>
Subject:      Engine Miss

Hi all and Merry X-mass to all
Since the last post I have
cleaned all earths
Replaced Leads and Cap.
Moved wiper plate in AFM.
Added the Capcitor fix to AFM.
Replaced temp 2 sensor.
adjusted throtle switch to correct settings.
Checked all readings from ECU to relative parts all fine.
checked idle stailizer valve and unit ( electricals).
Adjusted CO content by voltage of the O2 Sensor.
Cleaned Idle stabilizer valve.
Tune up to correct position.
Compression test all cylinders are at 145psi.

Question is still have miss through out rev zone and idle any ideas?
Symptoms are start van runs smooth for 30 seconds then miss kicks in. There
is no valve noise at all. After compression test all cylinders are equal
145psi. I am at a loss what futher to check and need some help from any one
please?
If there is any one from the Sydney area of NSW Australia that is willing
to help diagnos this problem by swaping parts plaese let me know.
Thanks SyncroPete.
92 VW Syncro Transporter
Push bike LOL.