Date:         Fri, 2 Jan 2004 00:26:27 -0500
Reply-To:     Mike Collum <collum@VERIZON.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Mike Collum <collum@VERIZON.NET>
Subject:      Front seal choice

I need to replace the front engine seal (between engine and trans) on my
'85 Westy along with the clutch, and I read in the archives that there
are two different seals (with one being better than the other) under the
same VW number.

Anyone know if the one that comes with the Elring engine gasket set is a
good one to use?  If not .... how does one make sure that the right one
is being ordered?

There is no part # on the seal but it does have "75 x 95 x 10 FPM / ACM
Elring"

Thanks,

Mike
Houlton, Maine
'84 GL 7 Pass
'85 GL Westy

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.