I don't have much experience on the bench installing pins I use a stand and I can spin the block so the rod stands straight up. I would think you could bend a coat hanger to support the rod so the pin could be installed Bob ----- Original Message ----- From: "Jeff Engel" <rambler64@SHAW.CA> To: <vanagon@GERRY.VANAGON.COM> Sent: Sunday, January 25, 2004 11:13 PM Subject: engine assembly
Hello I am in the process of assembling a 2.1 out of a 1990 westy.Was wondering if anyone out there has had experience with cylinder and piston install with the engine removedand on a workbench? Read bently and they talk about a special tool install the small clips for the wristpins. Can a person use any type of homemade tool or do I have to hunt down a special VW tool for this ? I have been getting excellent tech support from Bob Donald so far. Also are there any other things to be careful of when doing this job? Thanks Jeff 1990 Westy |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.