Date: Wed, 28 Jan 2004 18:30:13 EST
Reply-To: Trvlr2001@AOL.COM
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: John Carpenter <Trvlr2001@AOL.COM>
Subject: Re: 91(bus) dead on the freeway tech expertise needed !
Content-Type: text/plain; charset="US-ASCII"
Hi All,
Well, I got out the multimeter...
Juice on the large red wire terminal on the fire wall.
12v at the coil. But no spark at the plugs.
No fuel pump either.
12v at the key switch. It seems to be working.
I both checked the voltage at #4 relay slot, and replaced the switch, as well.
I seem to have power to the two relays in the black box, drivers side, engine
compartment.
Next, those relays? I put 12v to the switch sides, on the relays, #85 & 86, I
think.
they do (sound) like they are working, but how do I know for sure?
Can they be bought at flaps?
Or just the VW places?
Thanks to everyone for their help!
I've studied the manual, & I just get more confused?
But your systematic approach is helping immensely!
thanks again,
John C
SLC, UT
91 CRANKER, BUT NO STARTER....YET! :)
In a message dated 1/28/04 10:42:00 AM Mountain Standard Time,
twombleyw@JPS.NET writes:
On 1/28/04 8:55 AM, "mark drillock" <drillock@EARTHLINK.NET> wrote:
> You can easily test to see if the ignition switch is the cause. The
> switch uses a separate contact for the starter and another to turn on
> the ECU and ignition. The starter contact is obviously working. The
> other contact may be bad. You can test it at the relay panel. There is
> an empty relay socket in position #2. The 8 holes where a relay could
> plug in make convenient test points. Hole number 4 is connected to the
> ignition switch contact that turns on the ignition coil and ECU. Connect
> a voltmeter probe between hole 4 of relay socket#2 and ground. You
> should have +12 volts or so whenever the key is turned to ant on
> position. There should be 0 volts with the key off. If you have +12
> volts there during cranking and the engine does not start then the
> switch is NOT the problem.
>
> Mark
>
> John Carpenter wrote:
>>
>> Thanks Joel,
>> I went down to the bus this morning, and there is No fuel pump, initial
>> surge. Also no spark. I will change the key switch first, then test those
>> relays.
>> What is the best way to check them?
>> Thanks for your help!
>> John C.
>> SLC, UT
>> 91 Westy...
>>
Mark
|