Date:         Thu, 5 Feb 2004 12:46:41 -0500
Reply-To:     "sam.cooks" <sam.cooks@VERIZON.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         "sam.cooks" <sam.cooks@VERIZON.NET>
Subject:      Re: [Syncro] Re: Freezing throttle cable  temporary fix
Comments: To: brady horrace <dofunk@yahoo.com>
In-Reply-To:  <20040205165534.56674.qmail@web40310.mail.yahoo.com>
Content-Type: text/plain; charset=ISO-8859-1; format=flowed

Brady,

Perhaps I wasn't precise enough.  After pulling the pedal loose from the
linkage a few times, I began pulling on the linkage.

Pulling on the linkage attempts to push the cable back into the
housing.  If the cable is frozen farther back down the vehicle, it must
bend from this push and it must do so in a small space.  The fact that
it is a braided cable like a bicycle's gear shift cable and not a solid
wire like in the heater control,  which is designed to push and pull,
does not mean it will not bend.

The cable will not get a semi permanent bend as the solid wire heater
control cable would, but it will be bent nonetheless and in that short
space between the linkage and the housing.  Enough bends back and forth
and it seems that the cable will be compromised. That is where my broke.

Resolving the problem the way I suggested prevents the bending and
whatever potential damage to the cable that could occur from the
pushing.   Ounce of prevention type of idea.

Sam

--
Sam Walters
Baltimore, MD

89 Syncro GL
85 Westy Weekender
84 Vanagon, original owner, soon to be retired, just too many problems

All incoming and outgoing email scanned by
automatically updated copy of Norton AntiVirus.