Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (February 2004, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Tue, 17 Feb 2004 23:50:25 -0500
Reply-To:     Laurence Smith <laurence@ALANASMITH.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Laurence Smith <laurence@ALANASMITH.COM>
Subject:      Re: Left head ground
Comments: To: JM060356@AOL.COM
In-Reply-To:  <1d6.1a19b5f1.2d643121@aol.com>
Content-Type: text/plain; charset="US-ASCII"

Terminal 19 on the ECU is the ground wire for the O2 wire's outer sheath. It provides the sheild needed for the low voltage signal put out by the O2 sensor. It grounds to the left head and is bundled (and branches off) the same bunch of wires going under the intake to the Hall sender. As you mentioned, if you take the ECU connector off you should be able to find your ground using a continuity test. I am surprised yours is connected to the wall under the coil since that wire (in original format) is too short to reach that far.

- Laurence

---------------------------------------- Laurence Smith Hamilton, Ontario, Canada 90 Westy / 90 Subie 2.2 (in progress) 87 GL / 91 Subie 2.2 ----------------------------------------

> -----Original Message----- > From: Vanagon Mailing List > [mailto:vanagon@GERRY.VANAGON.COM]On Behalf > Of Jim Morgan > Sent: Tuesday, February 17, 2004 10:08 PM > To: vanagon@GERRY.VANAGON.COM > Subject: Left head ground > > > Greetings all. > I have a question concerning the l head ground. As I > understand it this is > the ground > that the ECU uses for richness? I have found in the archive > that if this > ground is not > grounded properly it will run rich. > I do not have this ground on the head. What I do have is a > grounded wire > going to the group of grounds unde the coil. > Now my question how can I find out which one of the grounds > belongs on the > head? > Does this ground have a number on the ECU plug? If so I can > just use a > continuity > tester on ECU plug number and just check each wire > individually. Is this a > reasonable procedure? if so would anyone now the number on > the ECU plug? > > Jim Morgan 86 Gl > 210,000.0 "bread box" > Westlake,Ohio > jm060356@aol.com >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.