Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (February 2004, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 19 Feb 2004 22:31:21 -0800
Reply-To:     Antaki <wrack@COMCAST.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Antaki <wrack@COMCAST.NET>
Subject:      Re: Sagging Wolfsburg/Carat Table
Comments: To: James V <tornadored@EARTHLINK.NET>
In-Reply-To:  <BC57C80D.B341%tornadored@earthlink.net>
Content-Type: text/plain; charset="us-ascii"

Ahh, the table with a malfunctioning or broken lock. It either sticks or won't hold at all. I went through two factory locking nechanisms, when I realized I had laying around what it takes to make a permanant fix, always holds, never sticks or breaks.

The mystery part? Why, that old broken or obsolete hard disk! Take it apart by finess or by force, and harvest the magnet in it's corner. Any 3.5" hard drive will contain some sort of super-strong magnet(s) in one corner, and corresponding steel plate (usually). Attach magnet to side of van interior, and steel plate to table. Violin, the table stays in place, but can be released fairly easily. The magnet could be mounted to the table, but it might erase your laptop's disk in that case.

To fix sagging, just rub the supports with a little slurry made of viagra and vasoline. (It's just about Fried day here!)

My two gauss worth,

Ron

Hmmm, viagra, magnets, hmmm.....

-----Original Message----- From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of James V Sent: Tuesday, February 17, 2004 1:31 PM To: vanagon@GERRY.VANAGON.COM Subject: Sagging Wolfsburg/Carat Table

The table in my 90 Carat isn't level when extended. The outer edge hangs probably 1"-1.5" lower. It doesn't really seem like there's excessive play before it "locks" - that is, I can only lift up on the table about .5"

Can this be adjusted?

Of less importance, it also doesn't lock in the closed position. I'm not sure if there is missing hardware but the pin/spring mechanism on the table appears complete/functional, and there is a metal ring in the receptacle on the side panel. But it won't click closed, no matter how hard I press.

Thanks yet again,

James 90 Carat


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.