Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (February 2004, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sat, 21 Feb 2004 08:37:07 -0500
Reply-To:     Jim Huskins <lostranger@MINDSPRING.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Jim Huskins <lostranger@MINDSPRING.COM>
Subject:      Still another Audi wheel question
In-Reply-To:  <BAY4-DAV10854OJZpwo00009edf@hotmail.com>
Content-Type: text/plain; charset=US-ASCII; format=flowed

I'm putting a set of 5000 Turbo wheels on my '91 Carat. I finally found the right spacers, and I've had all four centers machined.

Now, I'd like to use the Audi caps, but they don't fit the machined center bore. Can anyone offer a good solution for retaining the caps?

TIA

Jim Huskins Spruce Pine, NC


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.