Date:         Tue, 24 Feb 2004 13:21:18 -0500
Reply-To:     CTTAPER@AOL.COM
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Kevin Carrubba <CTTAPER@AOL.COM>
Subject:      Shift bar seperation and part # question
Content-Type: text/plain; charset=iso-8859-1

Hi Everyone,
Found out my shifter problem (I think)  whole bar is sagging some because the gromet at the gas tank is quite worn and is screwing up the geometry.  Any body know the part # for this on an 87 4spd?
Also how do you sperate the front and rear bar?  I have undone the clamp but they seem almost welded togeather.  Do I have to undo at the tranny end as well? Any tips would be great.
Thanks
Kevin
87 Westy
Burlington VT

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.