Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (February 2004, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 25 Feb 2004 20:11:57 -0800
Reply-To:     Mike Miller <mwmiller@CWNET.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Mike Miller <mwmiller@CWNET.COM>
Subject:      Re: heat slider switch
Comments: To: TheCoolestGuy87@AOL.COM
In-Reply-To:  <ea.47ea1027.2d6e7aa5@aol.com>
Content-type: text/plain; charset="US-ASCII"

The wire has been bent.

Maybe you can reach under the dash or through the ash tray hole and guide it back into the sheathing. Then don't open it past the point where it bent again.

Mike

On 2/25/04 2:24 PM, "Adam B" <TheCoolestGuy87@AOL.COM> wrote:

> Hey, > The slider switch for my heat control seems to be stuck. I can slide it to > one end and the other, but it pops back to the middle. Any ideas what i can do > to loosen it up? How do I get in there? > > Thanks > Adam > 86 Vanagon GL > >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.