Hey all... My rear engine support bar end caps were falling out due to rust around them. So i pulled them out. What should i use to seal the ends back up to keep water from getting inside? Or has anyone just drilled drain holes in the bottom of the bar to let the water drain out? Any thoughts or experience on this? thanks everyone, Jesse 89 carat |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.