You need anther wrench on the block that the nut tightens to, whatever that may be. There'll be a square surface somewhere to put wrench jaws on. Since you moved the assembly, even a little, I would advise mixing up some soapy water and brushing it liberally wherever there are fittings between the copper tube and the tank. It could be dangerous to have a leak there, but it's definitely going to be disappointing when you to to use your gas stuff and the tank is empty. Last weekend I installed a heater in mine, and I can tell you can't be certain the connections aren't leaking until you test with soap and water. Jim On Mar 2, 2004, at 3:54 PM, Jay Roth wrote: > I'm trying to remove my propane tank to replace the valve on my '87 > Westy and am > having a difficult time removing the tapered nut that connects the > copper tube > to the tank assembly. Every twist with a wrench results in the whole > assembly > turning. Any suggestions? Note: I don't believe it's ever been removed > before, > but have loosened the bolts holding the tank to the vehicle thanks to > PB Blaster. > > In VW Love, light & laughter > Jay > '87 Westy,"Ol' Blue," 327K > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.