On 3/11/04 9:23, "Al Knoll" <al_knoll@PACBELL.NET> wrote: > position. Berg has a set screw retained ring on the shaft to position the > spring. This design could be improved upon as the retainer needs only hold > the spring in place. Doesn't the Berg use the existing spring retainer? Can't this be reused similarly - slid up 3/4"? From what I understand from reading the Berg instructions that were posted, the kit includes a round sleeve that slides over the shifter shaft (below the pivot). What is its purpose? Thanks, James V 90 Carat |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.