Date: Wed, 10 Mar 2004 12:30:33 -0800
Reply-To: "McBryde, Connor" <Connor.McBryde@MED.VA.GOV>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: "McBryde, Connor" <Connor.McBryde@MED.VA.GOV>
Subject: 1.9 parts for sale
Content-Type: text/plain; charset="iso-8859-1"
I have left-over parts from my 1985 1.9L engine swap which hopefully some of
you might find useful in keeping your own 1.9 WBXs running. I had
refurbished the entire engine bay of my 1.9 in July 2002 with the intention
of swapping the parts to a Eurocars 2.2 engine in 2003; fortunately events
changed and I went with a Subaru 2.5L swap instead. However, this now
leaves me with all the engine accessories from the 1.9 (shortblock is gone)
taking up space in my garage, many of which were only run from July 2002 to
March 2003, less than 2,000 miles. I will entertain reasonable offers for
all of the parts below:
New parts installed 7/02:
Bosch factory rebuilt 90 amp alternator and mounting bracket, with warranty.
Bosch ignition wire set
Bosch distributor cap, rotor
Bosch oxygen sensor, single wire
Water pump, aftermarket/new from FLAPS.
Thermostat-new German in box, never installed.
Complete new engine compartment hose kit installed from Vanagain: this
includes the long rubber lines from the plastic hard lines to the waterpump,
all waterpump hoses, crossover pipe hoses, and the hoses attached to the
plastic H-pipe.
All new metric rubber fuel hoses on engine; fuel injectors are old and need
new O-rings.
Old parts (engine had 144,000 miles at time of removal):
Sanden A/C compressor and cast aluminum bracket-last ran approx 8 years ago,
never recharged due to system leaks.
Power steering pump-ran fine, no leaks. No PS hoses, however.
Digijet AFM
Both header pipes, front is moderately rusty/fair condition, rear has
minimal rust/good condition.
Header J-connector pipe, fair condition
Complete engine bay wiring harness (all connections labeled)
Ignition coil, distributor, transistorized ignition module, relay box
idle stabilizer valves
1.9L ECU
plastic H-piece near expansion tank.
Flywheel in good condition
temp I and II sensors.
Fuel pressure regulator
Most exhaust mounting brackets
If interested in anything above or not listed please contact me by P-mail.
Otherwise E-bay or junkyard are next.
Connor
85 Westy/02 2.5 Subaru
|