Date:         Tue, 16 Mar 2004 13:18:22 -0500
Reply-To:     Rick Koller <rkoller@HELIX.NIH.GOV>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Rick Koller <rkoller@HELIX.NIH.GOV>
Subject:      Hall sensor install
Content-Type: text/plain; charset="us-ascii"; format=flowed

Hi All,
        I have a distributor (2.1 liter engine) with a bad Hall, I have the new
Hall. Question is, how does one remove the small pin at the bottom of the
shaft to take apart the distributor. I have tried a punch without a hint of
movement of the pin. Anyone have any tricks to do this? Heat?
Thanks
Rick Koller
'90 syncor west, 2 '91's

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.