Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (March 2004, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Tue, 23 Mar 2004 14:23:24 -0800
Reply-To:     zolo <zolo@FOXINTERNET.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         zolo <zolo@FOXINTERNET.NET>
Subject:      Re: I'm about to give up...
Comments: To: mark drillock <drillock@earthlink.net>
Content-Type: text/plain; charset="iso-8859-1"

That should be the one. Makes all the sense too. I am going under the car and put it the the other side to have more travel. Thanks a million. Zoltan ----- Original Message ----- From: "mark drillock" <drillock@earthlink.net> To: "zolo" <zolo@FOXINTERNET.NET> Cc: <vanagon@GERRY.VANAGON.COM> Sent: Tuesday, March 23, 2004 2:21 PM Subject: Re: I'm about to give up...

> What year is it? The waterboxer type linkage can be reinstalled wrong at > the tranny end. The plates that sandwich the shifter guide bushing can > be bolted to either side of the ears that stick out of the tranny. If > you put it on the wrong side of the ears then the range of travel is > limited in one direction. This is a common error when putting the > linkage back on the tranny. (Air-cooled and 82 diesels don't have this > setup and thus can't be done wrong in this fashion.) > > With the tranny in neutral, look at the shift rod where it passes > through the guide bushing. You should have equal amounts of wear showing > on the rod on both sides of the bushing. If not, move the bushing > mounting plates to the other side of the ears. > > Mark > > zolo wrote: > > > > I am adjusting the transmission shift linkage. The second and the fourth gears are not going in deep enough, only get to the top of the gears and they would just grind if I let the clutch up. From neutral the first and third have enough travel, but the second and fourth have only half the distance. > > What is wrong here? How do I get more distance for that two gears. Moving the rod further in front, only results in the shift knob position going more forward but does not add more movement into those gears. I can't find in the Bentley any reference. > > Zoltan >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.