Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (March 2004, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 25 Mar 2004 09:27:56 -0800
Reply-To:     David Marshall <vanagon@VOLKSWAGEN.ORG>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         David Marshall <vanagon@VOLKSWAGEN.ORG>
Subject:      Re: CB antenna mounting - Structural strength
In-Reply-To:  <Pine.BSF.4.58.0403251003430.57839@gull.us>
Content-Type: text/plain; charset="us-ascii"

If you are going to mount an antenna do it right! :) First, loose the Westfalia and get a Double Cab. :) Then get some AS/1729 military antennas that run through an antenna tuner and then to a 100W HF radio that will cover CB frequencies and a whole bunch more. See http://www.syncro.ca for details on my TriStar's antenna system.

For my Westfalia, I have more of a problem as I have a high top version with no luggage rack. I will be mounting a CB antenna just above the rear engine intake vent - the antenna will be a 1/4 wave coil loaded unit. It will *just* be taller than my camper top. It isn't optimal at the corner of the vehicle, but there is a large ground plane next to it - just as much as the front. I will also have an easy time with the RG-58 coax cable as it can run under the van and then up the vent tunnel to the antenna. I will be running an antenna tuner with this too and an HF radio as well - should be good to about the 40m band.

David Marshall

Fast Forward Automotive Inc. 4356 Quesnel-Hixon Road Quesnel BC Canada V2J 6Z3

http://www.fastforward.ca mailto:sales@fastforward.ca Phone: (250) 992 7775 FAX: (250) 992 1160

- Vanagon Accessories and Engine Conversions - Vanagon, Transporter and Iltis Sales and Importation - European Lighting for most Volkswagen models

Due to the large volume of email we receive, PLEASE include previous emails when responding. This will allow us to read the complete dialogue in one message and will result in quicker and more accurate responses.

-----Original Message----- Subject: Re: CB antenna mounting - Structural strength

On Thu, 25 Mar 2004, Mark Carrig wrote:

> My question is, is the fiberglass rack strong enough to support the 3' > antenna in moderate road winds that you encounter when driving at speed ? > > Will it crack, of fatigue ?


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.