Hi Volks, Almost a happy camper. I put in my new Throttle position switch and adjusted it and it is much happier. Everything on the digitool seems to be good. But... I set the idle with the Idle stailazer and 02 sensor disconnected (warm temp) and it ran great. Then I pluged them back in and I got a bouncing idle again. It drives great 02 sensor is bouncing like it should. Great throttle responce smooth all the way through to 4k rpm. Can I drive it with the 02 sensor pluged in but the Idle stabilzer unpluged will it hurt anything or just idle crappy when cold? I can try a new isv and iscu (used) tomorrow but would like to isolate it as that's my problem. Just a side note my ISV I cleaned with brake cleaner but I still can blow throught it should it be clogged like that when cold. The last one I borrowed you could blow through a little. Thanks Kevin 87 Westy Burlington VT --- Outgoing mail is certified Virus Free. Checked by AVG anti-virus system (http://www.grisoft.com). Version: 6.0.648 / Virus Database: 415 - Release Date: 3/31/2004 |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.