hey all, finally got my used 84 auto transmission delivered.. to my surprise it came with the torque converter... i removed the torque converter to check for leakage at the seal. There was only a little bit of oil around the seal.. but i am going to replace it anyway. My question is this. On the seal surface on the torque converter.. there is a groove .. is that suppose to be there? This is my first run in with an auto trans.. and am a bit of a newbie.. i just want to make sure i don't miss anything before i put the trans in... any info would be grand.. thanks all, jesse 89 carat ps. wanted to thank everyone for there input on whether the 84 trans would fit into my 89 van... thanks for helping me make sure i did not buy a big paper weight!! |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.