Date:         Wed, 14 Apr 2004 13:19:59 -0700
Reply-To:     Craig Oda <craigoda@COMMUNITYBUILDERS.INFO>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Craig Oda <craigoda@COMMUNITYBUILDERS.INFO>
Subject:      Re: lifter replacement
Comments: To: ROBERT DONALDS <donalds1@verizon.net>
In-Reply-To:  <193001c421c7$b39484c0$6401a8c0@yoursz6x6sefxo>
Content-Type: text/plain; charset=ISO-8859-1; format=flowed

Bob,
thanks for the answer.  My concern is indeed whether or not the oil will
leak out when I pulled out the lifter.

I already ordered two push-rod tubes and 2 lifters from Ken.  I think
only one lifter is bad, but I bought a spare set just in case.

I have a mechanics stethoscope from Sears.  So, I'm going to listen for
the specific lifter this weekend ( I think it is cylinder 1 closest to
the front) and the take off he rocker arm assembly and pull out the
pushrod.

I hope that oil doesn't gush in my face when I pull that lifter out.
I've got a lot of stuff drip in my face from my van over the years.  ;-)

Regards,
Craig


ROBERT DONALDS wrote:

>the oil will not leak out if that is your concern unless the van is at an
>angle. The replacement push rod tubes are in short supply. so have them in
>hand before you tear out the old one try Ken a vanagain for replacement
>tubes
>Bob
>----- Original Message -----
>From: "Craig Oda" <craigoda@COMMUNITYBUILDERS.INFO>
>To: <vanagon@GERRY.VANAGON.COM>
>Sent: Tuesday, April 13, 2004 10:08 PM
>Subject: lifter replacement
>
>
>
>
>>Do I have to drain all the oil from the crankcase in order to replace a
>>lifter?  I ordered new lifters and a few of the spring-loaded pushrod
>>tubes and plan to remove the pushrod, break the old tube and get the
>>old lifter out with a magnet or something.
>>
>>Before I do this, should I drain all the oil from the case?
>>
>>
>>
>
>
>