Date:         Sun, 18 Apr 2004 21:16:22 -0400
Reply-To:     Eric Zeno <vw4x4@FYI.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Eric Zeno <vw4x4@FYI.NET>
Subject:      Re: 86 Vanagon - Engine won't start
Comments: To: "Stylianides, Georgios" <gstylia@TEMPEST.COEDU.USF.EDU>
In-Reply-To:  <408320E8.30903@coedu.usf.edu>
Content-Type: TEXT/PLAIN; charset=US-ASCII

Pull the dis.c ap and check the rotor.  They have same resistors built in.
It will be obvious if it is burned out, enough not to start the engine.

            Eric                   86-VW4x4
            vw4x4@fyi.net          86-SS Syncro
            Pittsburgh, PA USA     1936-Chrysler
                                   92-Jetta GWC
            www.fyi.net/~vw4x4/vw4x4.htm

On Sun, 18 Apr 2004, Stylianides, Georgios wrote:

> We hope we can get some input on this:
> While driving our Van died on us. Just died. No warnings of any sort. We
> looked in the engine compartment and the alternator seemed to have been
> fried. Actually, it literary fried.
>
> I replaced the alternator and belt but the Van will still not start. I
> was told that when the alternator fries like that, an overload takes
> place and other ignition/timing components may be damaged.
>
> Any input would be greatly appreciated. We tried a couple of tests for
> some components and they seemed to be fine. We also replaced the
> ignition coil and ignition spark plug wires, including the spark plugs.
> The engine cranks fine and spark goes through the plug wires, but we
> seem to be getting no spark in the engine, and we smell gas after
> cranking it for a couple of times. We assume it is an ignition/timing
> issue.
>
> Vanagon 1986, 2.1 gas MV engine, Digifant
>
>
> george
>