"My headlights are a bit floppy on the outer edge, meaning if you push on the outside edge, they will push in about an inch on the side and spring back out."
and........ "One answer I can't find in the archives: Will the square E-codes fit into the stock square buckets and grill of an 86-91? Projektzwo is too expensive for me, and I think I prefer to remain rectangular . . ." I'm not positive but believe these lights fit right into the stock van square buckets. Leave a question for David Marshall at the below link. http://www.fastforward.ca/Lights/default.htm Not cheap by any means but apparently very effective. The headlight adjuster kit is on this same page as well. bob |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.