Hello All. I am currently in the middle of the dreaded " head reseal " project and I need to know what do i set the valves to? Checked the archive and found it very confusing. The two turns in the bently manual is wrong? been to boston bob's site and only found a artical about bleeding lifters. To late the head is back together so do I just set them to .006 and check again in a week after they quiet down?
Jim Morgan 86 Gl 210,000.0 "bread box" Westlake,Ohio jm060356@aol.com |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.