Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (April 2004, week 5)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 29 Apr 2004 18:53:26 -0700
Reply-To:     Jeff Couture <jefe6@YAHOO.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Jeff Couture <jefe6@YAHOO.COM>
Subject:      Removing Center Drive Shaft on Syncro (Bad VC)
Content-Type: text/plain; charset=us-ascii

I noticed that my VC is going bad (acts like a brake in not so tight parking lot turns) so I want to pull my drive shaft until I can get a replacement. I know that I should mark the driveshaft to make sure I put it back in the proper alignment, but I wonder if anyone has a good method for doing that. I was about to grab a dremel tool and score a mark on all four flanges but then I started thinking that the reason the shaft has to be aligned is for balance. Would such a mark have a significant effect on the balance? Any other ideas? Thanks

Jeff 86 Syncro

__________________________________ Do you Yahoo!? Win a $20,000 Career Makeover at Yahoo! HotJobs http://hotjobs.sweepstakes.yahoo.com/careermakeover


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.