Hey all, The new engine i bought came set up for a manual transmission. I removed the flywheel, but i have a few questions. One is... there is a needle bearing pressed into the crank.. can i just leave it in even though i don't need it for an auto setup? Two is... do i need to remove the shims that were used to set the endplay? If so.. do i have to remove the rear seal to get them out? I would assume since i don't have a clutch pushing on the end of the crank.. that there is not need to set end play.. and the thrust bearing takes care of all that... Any help on this would be grand.. thanks all, jesse 89 carat |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.