Check out Frank's Fridge Maintenance doc at http://members.aol.com/Fkc43/fridge.htm In particular, step 20, which reads: "One more thing to check is the LED on the control panel. It should be lit when the fridge is running. If your sure the fridge is running, a simple method is to touch the exhaust pipe, it should be hot so be careful, and the LED is not working you need to check the single black wire, the same one we checked before, to the control panel and if your sure that is correct then you need to check the board. Could be the board, LED, resistor or most likely the LM324, Radio Shack part #276-1711, chip which controls the LED on the control panel board is dead. The LED, resistor and chip can be replaced by obtaining them from Radio Shack then unsoldering and removing the defective piece and soldering in the new one."
>Here's an additional question for all. If my frig LED wont light when it's running on >propane, it has never lit up. What should I check to see if I can get that 'snowflake' >LED working again? |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.