I had gotten conflicting answers to my question that i posted earlier so i am posting it again... just to make sure i have the right info.. I have to convert my new engine from a manual trans setup to an auto trans setup... questions were.. do i have to remove the little guide bearing in the end of the crank that is there for the manual trans? i got a reply that the torque converter will not seat properly if it is not pulled out.. and second.. is.. do i still have to set the end play even though i am not using a clutch? I am fairly sure that i do.. but just want to make sure... also.. if anyone is in need of a new flywheel P-mail me with an offer... thanks everyone, jesse 89 carat |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.