http://www.engineceramics.com/vw/plug11.jpg I've posted a picture for you. If that rectangle shield is missing from your plug location the plug can go on 1 position off and that will cause bad readings and other problems. Stan
----- Original Message ----- From: "Max Wellhouse" <maxjoyce@IPA.NET> To: <vanagon@GERRY.VANAGON.COM> Sent: Sunday, May 09, 2004 3:08 AM Subject: Tach-side PC connection?
> Hey listees, I accidently disconnected the long skinny plug in connector > while having the dash frame out the other day. I thought I got it back in > correctly, but no!; the gas gauge and water temp needles read higher than > they should. Where did I screw up? I can't find a photo of this > connection anywhere in Bentley. > > TIA > > DM&FS |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.