Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (May 2004, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 12 May 2004 09:37:31 -0400
Reply-To:     David Brodbeck <gull@GULL.US>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         David Brodbeck <gull@GULL.US>
Subject:      Re: Draining the coolant system... ?
Comments: To: Doug in Calif <vanagon@ASTOUND.NET>
In-Reply-To:  <002501c437b7$7e6b4a80$d9032a45@ttowerdef17>
Content-Type: TEXT/PLAIN; charset=US-ASCII

On Tue, 11 May 2004, Doug in Calif wrote:

> Imagine that, VW with their seemingly endless research and design team > puts together a factory service manual procedure for purging the > extremely long and complex cooling system of the vanagon.

Remember that the VW procedure assumes that the van is in a shop, and that the mechanic gets one chance to bleed the system and then will never see the van again.

As long as the system isn't air-locked to the point where the van overheats, if you just go for a short drive after bleeding it any remaining air will naturally collect in the radiator. When I bleed my cooling system, I leave the grille off for the first drive, and when I get back home I crack the bleeder with the engine hot and idling. After following the Bentley procedure for the diesel (which is a little different than for the gas model) I usually get the tiniest bit of additional air out this way. Is it enough air to cause a problem? Probably not, but it makes me feel good to get it all out. It also means that if I find air up there later, I know I have a head gasket problem or a pinhole leak in the radiator.

Both the Bentley procedure and the one you're debating about make logical sense...the only difference is where the air goes. Bentley lifts the front to make the air get up there more easily. TJ lifts the rear until the coolant bottle is above the top of the rad. Note that this means lifting the van really high...I mean SCARY high, high enough that you're kinda nervous about getting too close to it. So that may be why it's not the Official Procedure.

David Brodbeck, N8SRE '86 Volvo 240DL wagon '82 VW Vanagon Westfalia Diesel


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.