VANAGON archives -- May 2004, week 2 (#678)

Date:         Fri, 14 May 2004 13:34:43 -0700
Reply-To:     Jason Kirk <Gojira@ADELPHIA.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Jason Kirk <Gojira@ADELPHIA.NET>
Subject:      Re: drilling through sheet metal?
Content-Type: text/plain; charset="iso-8859-1"

That may be taken as a joke, but there's a good probability he's right. Also
make sure that you have the right end of the bit inside the drill.

Jason

----- Original Message -----
From: "George Goff" <THX0001@AOL.COM>
To: <vanagon@GERRY.VANAGON.COM>
Sent: Friday, May 14, 2004 1:20 PM
Subject: Re: drilling through sheet metal?

> In a message dated 5/14/04 3:53:53 PM, craigoda@GMAIL.COM writes:
>
> << I've also tried to drill a hole into the pillar where the fire
> extinguisher is attached to.  I haven't had any luck here either.
>
> Are there any special techniques? >>
>
> Stop running it in reverse.
>
> George
>

Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.