Hi Somebody could tell me if the RPM should move when the starter is cranking the motor? I suspect my hall sender is defective. I had hard time to start my motor when hot. Now I cannot start it anymore. The small connector on the distributor is very loose. There are 3 small wires (red, black and gray) which come out from the distributor. I got around 12Vdc between the red and the black. I removed the distributor and put 12Vdc between the red and the black for testing. I am reading millivolt between the black an the gray. Anybody knows which voltage I should get on the gray wire? Germain |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.