Well, Doug, You know that part in my email where I paid? Thatıs cause I donıt have a clue how to do it myself, including what it looks like. I know the input shaft is involved because I paid for one of those. Sorry for the ignorance. Mike
On 5/21/04 7:41 PM, "Doug in Calif" <vanagon@astound.net> wrote: > Hey Mike, > a quick question regarding the pilot bearing. > The parts diagram shows the bearing in the end of the crankshaft and a seal > also? > > When I pulled my 2.1 down it had what looked like what was left of a pilot > bearing in the flywheel center bore. > Nothing should go in the flywheel correct? > > Both bearing and felt seal go in the crank and the flywheel bore is clear > right? > > Thanks, > > Doug |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.