Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (May 2004, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Tue, 18 May 2004 17:30:40 -0500
Reply-To:     Jim Felder <felder@KNOLOGY.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Jim Felder <felder@KNOLOGY.NET>
Subject:      Re: windshield replacement
In-Reply-To:  <40AA89DB.6020205@bellsouth.net>
Content-Type: text/plain; charset=US-ASCII; format=flowed

Don't forget that the bentley says to squirt come kind of mastic in the groove of the rubber surround. I copied pages out of the bentley and had the body shop follow those instructions.

Jim

On May 18, 2004, at 5:10 PM, John Rodgers wrote:

> Haven't done the window installation thing myself, but if you need to > have the glass or rope slide in the rubber, use DC4 compound on it. > I't's a Dow-Corning Silicone dielectric paste used heavily in the > aircraft industry and it works slicker than owl dung. Ask for it at > some > of the electrical supply houses. Bet they carry it as well. > > Regards > > John Rodgers > 88 GL Driver > > Robert Harris wrote: > >> Ouch!! My Westy's windshield got smashed in transport by an auto >> hauling >> company (hate to see her in pain like that but I got a decent >> settlement >> from those cretins in the end). I'd like to install the new glass >> myself >> if possible and have already removed the broken one. The Haynes >> manual >> gives no instructions, but after consulting the listserv archive >> (what a >> terrific resource) I'm all set to give it a try. Trick seems to be to >> lay >> 1/4" rope into the crevice of the new seal and have a helper hold the >> glass >> up against the opening while you work from inside. You slowly pull >> the >> rope out from around the seal from inside the van, which pulls the >> flap of >> the seal in around the body opening. >> >> Soo... for anyone who has attempted this, what kind of sealant should >> I >> use, if any? I was thinking 3M Weatherstrip Adhesive. And any other >> words >> of wisdom come to mind for doing the job right the first time? >> >> thanks, >> Robert Harris >> '84 Westy >> '95 Subaru >> '93 Honda CB750 >> >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.