Date:         Sat, 22 May 2004 01:33:05 -0400
Reply-To:     Jonathan Farrugia <jfarrugi@UMICH.EDU>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Jonathan Farrugia <jfarrugi@UMICH.EDU>
Subject:      bumper bolts
Content-Type: TEXT/PLAIN; charset=US-ASCII

could some one with a straight bumper measure the center to center
distance of the rear bumper bolts.  i backed into a pole yesterday and
mutilated my bumper.  so today i beat it back into submission but the
holes are off.   this bumper was plenty tweaked when i got it so the holes
were already a bit off.  to get it to fit after the latest pounding
session i had to slot each of the holes about 3/16".  the bentley gives
dimensions for the distance between the frame rails but i am wondering if
my bumper mounts are bent.

jonathan

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.